Included accessories let the button be worn on a wrist, carried as a pendant, clipped to a belt, or secured to a flat surface. It also accepts compatible 38/40/41 mm Apple Watch-style bands. A CR2032 battery provides up to five years of service, and the LED ring confirms the detected press pattern and transmission. The manual recommends operation within 100 feet of the panel, followed by an actual signal test.

Allied can configure the WST-130 as a wearable panic button, a fixed hold-up control, or another approved command based on the property’s needs and monitoring plan.

The cylindrical transmitter fits a 3/4-inch-wide by 2.5-inch-deep hole, while the magnet uses a matching 3/4-inch opening about 1/2 inch deep. A replaceable CR2 battery is rated for five years and the sensor checks in approximately every 60 minutes. Opening the transmitter cap also sends a tamper signal to the panel.

Allied evaluates the door material and frame depth before drilling, aligns the magnet through the complete door travel, and verifies the DSC 433 MHz signal after installation.

Flood and freeze functions use separate electronic serial numbers, allowing the compatible DSC panel to identify which condition occurred and apply the appropriate response. A CR2450 battery supports up to seven years of service under the current manual, with low-battery reporting and supervised check-ins about every 64 minutes. The optional mounting adapter and water-detection rope can extend sensing into harder-to-reach areas.

Allied places the WST-620 where water is likely to appear first, such as near a water heater, washing machine, sink, toilet, or mechanical equipment, then tests both enrollment and radio reception.

The sensor mounts with its listening ports facing the existing alarm’s sounder and must remain within six inches for proper operation. One FireFighter may monitor an interconnected alarm group because all sounders activate together; non-interconnected alarms require a listener at each sounder that needs monitoring. Separate smoke and CO serial-number programming allows the panel to distinguish the two alarm types.

This device can extend monitoring around existing smoke and CO alarms without replacing their primary sensing function.

A red LED confirms each wireless transmission, and the black housing with chrome metal trim is designed for regular key-ring carry. The remote is water resistant and uses one replaceable CR2032 battery with an expected life of up to five years. The default three-second panic delay can be enabled or disabled by the installer to suit the approved system design.

Allied enrolls the correct serial number, confirms every button assignment, and tests the remote within the actual use area.

A mechanical tilt element and slow-loop response are designed to ignore brief movement from vibration or wind while still reporting a meaningful change in door position. The replaceable CR123A battery is rated for five years, and the extended -22 to 120 F operating range is well suited to unconditioned attached garages. The sensor communicates with compatible DSC 433 MHz receivers.

Allied verifies the closed and open orientations, tests the wireless path with the door in place, and confirms the programmed zone behavior before handoff.

Pet-immunity processing is rated for animals up to 85 lb when the sensor is installed at the specified 7.5-foot height and the room follows the placement guidance. Normal and High sensitivity settings let the installer balance capture performance against environmental activity. After an alarm transmission, a three-minute lockout reduces unnecessary radio traffic and helps the CR123A battery reach its five-year expectation.

For a dependable home security installation, Allied checks the final 433 MHz signal and walk-tests the complete pattern before closing the job.